Davison-machinery

High Frequency Welding Machine parts generally not easy bad, usually need to pay attention to maintenance, high Zhou Boji generally to dust is more sensitive, if you have any lighter dirt easily, bucket needs regular cleaning

It’s possible problems: a, mold temperature. Mold temperature change will produce quality is not stable, high frequency output to raise as much as possible, at the same time to reduce the high frequency output time. Because the lighter is often because the material can’t stand hot weather. 3, check that the mold is parallel to the bedplate. Four, mold size and high Zhou Boji do not match, making machine output power decrease effectively. Five, transformer or ac contactor poor contact, make the output current of electric current. Six, processed products bad, because there are mesa adjust bad, mold problem.

Note: when touching the lower die mould press, grounding copper must pin was set, round copper can be a little deformation. If the grounding copper didn’t adjust good, the machine will not be able to work steadily. When change the different height of mould which grounding copper should be reset again.Note: when touching the lower die mould press, grounding copper must pin was set, round copper can be a little deformation. If the grounding copper didn’t adjust good, the machine will not be able to work steadily. When change the different height of the mold when the grounding copper need to reset it again. High Zhou Boji use machine operation and precautions:

  1. Keep the machine working mesa clean, do not put water and other liquids that day, in case of dumping, damage device in the machine.
  2. Clean the ground, don’t let the water splash into the machine, in case of damage to the transformer be affected with damp be affected with damp.
  3. Open the machine power supply must have 3-5 minutes of preheating, the machine can be used after the various components to reach a steady state.
  4. Do not make any rap work on the machine table, in case the vacuum tube is damaged.
  5. In the operation, the hand do not touch the red die and mould, to prevent high frequency burns
  6. Need to empty, must put matcher red pointer to zero.
  7. Clear the residual clutter on the template in time, so as not to affect the quality of the product.
  8. Regularly changing wind oil drain tube in the oil, to ensure the purity of the air pressure.
  9. Do not use any part of the body and debris into the template between up and down, pay attention to safety operation.
  10. Don’t use hand to touch the live wire, so as to avoid electric shock accidents.
  11. A month to PVC Welding Machine the activity parts regularly inject embellish oil or grease. Half an year is clean up the case of internal health.
Read more